Inspecting the water supply lines is essential for maintaining and repairing any home plumbing system. If you are not familiar with properly checking your water lines, it can be easy to overlook potential problems that could lead to costly repairs in the future. This article will teach you how to properly inspect your entire water supply system so that you can avoid these common mistakes when inspecting your water supply systems.

How to properly inspect your water line for issues or leaks

When inspecting your water supply system, there are several things you should look at:

1) Your Water Meter

Inspect this first because if it’s wrong, then everything else will be bad too. Your meter has likely been tampered with by someone who wants to ensure that they get as much money from your utility company as possible. You can tell if your meter has been tamper-proofed by looking at the dials on the side of the meter box. The dials should have an arrow pointing upon them. If the dials do not point upwards, your meter has probably been tampered with.

2) Your Water Main

This is one of the essential parts of your water supply system. Make sure that all joints between pipes are tight. Also, make sure that the pipe is level so that it does not cause damage to your house. You do not need to remove the pipe to check it. Just pull back the cover plate where the pipe enters your home. Look for cracks and corrosion. These areas may indicate that the pipe needs replacing.

3) Your Faucets

Make sure that each faucet is working correctly. Check the washer and the nuts holding the faucet together. If anything looks loose, tighten it down. Also, make sure the shutoff valves are closed. Turn off the main valve and close the shutoff valves if they aren’t. This will prevent water from leaking out of the system.

4) Your Pipes

Check each joint between pipes. If something appears loose, tighten it down before turning on the water again. You don’t need to remove the lines to check them. Pull back the covers where the pipes enter your house. Look around for cracks and corrosion. Cracks and corrosion can indicate that the pipes need replacing.

5) Your Drains

Look for clogs in drains. Clogs can cause significant flooding if they are not fixed quickly. To specify a clog, use a plunger. Place the end of the plunger inside the drain and push down until it reaches the clog. Then, slowly pull the plunger out while pushing down on the sides of the gutter. Do this until the clog comes out.

Conclusion

Hopefully, after reading this article, you learned some new tips about properly inspecting your water supply system. If you follow these tips, you can help ensure that your water supply system is safe and functioning well.

 

For more information, contact Vinny’s Jersey Plumbing, located in Wayne, New Jersey. We also service other cities in New Jersey, such as Parsippany, Little Falls and Elmwood Park.